Design Maximum Power Point Tracking (MPPT) on Photovoltaic Panels using Fuzzy Logic Method
- 1 Universitas Islam Negeri Sultan Syarif Kasim, Indonesia
- 2 Universiti Kebangsaan Malaysia, Malaysia
Abstract
Solar energy is a clean energy, renewable, and available for the long term. The tool used to convert the energy generated from the intensity of sunlight into electricity is photovoltaic panels. However, due to the high cost and low efficiency, the use of the energy is still kind small compared to other types of energy sources. Thus, the need for an effective and flexible models, which resemble the characteristics of the actual photovoltaic (PV), so that we can perform simple manipulation of some data to figure out how to get the maximum performance possible. The characteristic of the solar panel output is specific and non-linear, it depend on the solar irradiation and the temperature of the solar panel. Because of it, it makes us difficult to get the Maximum Power Point (or abbreviated MPP) of the solar panels. Approach: Therefore, to solve these problems required the modeling of the solar panel for design and simulate the algorithms of Maximum Power Point Tracking (MPPT) to maintain the working point of solar panels fixed on the MPP. Overall, the designed system results carried are running well. The increase in the average value of the output voltage by 17%, from an average of 11.6 V before installation into 13.94 V after installation MPPT system. It also occurs in output power with an increase of 28%, from an average of 35.13 W before installing system MPPT into 48.9 W after installation MPPT system. The temperature effect on module voltage and output power before and after installation of the MPPT system that after the installation of the MPPT system, the voltage output of photovoltaic modules can be maintained around the desired maximum value that’s equal to 12 V. But there was a drop in output power value compared to the prior installation MPPT system. This is caused by the output current value that cannot accommodate the value of the output voltage. So that the value of the output current is enough to produce the maximum output power is needed quantities corresponding load.
DOI: https://doi.org/10.3844/ajeassp.2016.789.797
Copyright: © 2016 Ahmad Faizal, Sutoyo, Mulyono, Rado Yendra and Ahmad Fudholi. This is an open access article distributed under the terms of the
Creative Commons Attribution License, which permits unrestricted use, distribution, and reproduction in any medium, provided the original author and source are credited.
- 3,991 Views
- 2,584 Downloads
- 7 Citations
Download
Keywords
- Solar panel
- MPPT
- Fuzzy logic method
- Buck-boost DC-DC converter